« Last post by zach_a_ary on March 01, 2024, 09:46:59 PM »
i deleted the basic label and added the basic indicator. Here are some screenshots I took. I might have missed a step somewhere. 192.168.70.10 is the ip i need.
« Last post by paintman on February 29, 2024, 11:18:57 AM »
Awesome, for my situation with the array, it may be Paintpart[23] and the associated elements, or [65] depending on the carrier number at the station. With the data subscriber it looks like I can only call specific tags and not have a variablized tag. Would I need to just call the base name Paintpart then specific the actual tag location later in the code?
« Last post by paintman on February 29, 2024, 10:02:39 AM »
Does the datasubscriber work for multiple PLC tags or is it for a single tag per subscriber? Currently the most important one I am trying to read is an array of tags with 8 elements to each tag.
Or would it be best to just setup the data subscriber to read the stop release bit and then run the full sequence of code?
Also does the datasubscriber read two way changes? Like if the bit changes from 0 to 1 it runs the sequence then when it changes back from 1 to 0 it reads again?