Author Topic: Modbus RTU via IP address and port... ?  (Read 1724 times)

ecoulombe

  • Guest
Modbus RTU via IP address and port... ?
« on: September 23, 2016, 11:08:09 PM »
Hi! New to the forum. Great software.  I worked for many years with A-B stuff... now with HVAC, much less powerfull stuff...

Can you add the possibility to enter an ip address in  place of the Com port and a port number in place of the port speed.
I am using a Ethernet/Serial converter (Lantronix UDS1100) to talk to a modbus device... so i need the lantronix software
on each windows PC that I use. (Not at the same time)   

I use a GPS software doing this... no in between driver software needed. (http://www.turboirc.com/gps7/)

This feature can add more portability to any system... even raspberry PI?

Thanks!
Eric