Author Topic: TwinCAT 3  (Read 985 times)

Archie

  • Administrator
  • Hero Member
  • *****
  • Posts: 5260
    • View Profile
    • AdvancedHMI
TwinCAT 3
« on: December 17, 2017, 07:51:42 PM »
On a few occasions the question came up about the compatibility of AdvancedHMI with TwinCAT 3. Previously I did not have a good answer because I only tested it with TwinCAT 2. I finally had the opportunity to test it and found out that it does work. The main difference is the TargetAMSPort will start at 851 by default.