AdvancedHMI Software

General Category => Support Questions => Topic started by: Joe Matkowski on April 03, 2017, 01:09:27 PM

Title: Message list by value time stamp
Post by: Joe Matkowski on April 03, 2017, 01:09:27 PM

I am sure I am just missing something and not searching enough but is there a way to time and date stamp when the alarm fired, I have all of my alarms in an .ini file?
Thanks
Jody

Title: Re: Message list by value time stamp
Post by: Archie on April 03, 2017, 04:50:43 PM

It should have a ShowTimeStamp property.

Title: Re: Message list by value time stamp
Post by: Joe Matkowski on April 04, 2017, 11:30:30 AM

I had seen that property in another post it should show up close to "ShowMessageNumber"?

jody

Title: Re: Message list by value time stamp
Post by: Godra on April 04, 2017, 02:50:18 PM

I just checked AHMI versions 3.99t and 3.99w and both have the property.

You must be using earlier version that doesn't have it.

You might try creating a copy of your solution and replacing your control with later version (if it doesn't work properly then try upgrading to the latest version of AHMI).

Title: Re: Message list by value time stamp
Post by: Joe Matkowski on April 04, 2017, 02:53:34 PM

this is 399w, let me go unzip another copy and see if it show up in blank app Thanks

jdm

Title: Re: Message list by value time stamp
Post by: Joe Matkowski on April 04, 2017, 02:58:59 PM

Went and downloaded a fresh zip folder and it showed up.. Thanks guys.

jdm