AdvancedHMI Software

General Category => Support Questions => Topic started by: arizawilmer on September 19, 2019, 07:35:21 PM

Title: MODBUS TCP/IP address register for loadcell amplifier
Post by: arizawilmer on September 19, 2019, 07:35:21 PM

Hi,

I am trying to interface a DAD141.1 load cell amplifier.

https://www.flintec.com/media/downloads/DAD141_Modbus-Communication_Rev.2.3_EN.pdf (https://www.flintec.com/media/downloads/DAD141_Modbus-Communication_Rev.2.3_EN.pdf)

The available functions are:
(https://i.imgur.com/ptP3Hh0.jpg)


the index that I am trying to read is 0x2020 that in decimal is 8224

(https://i.imgur.com/FCWQBCE.jpg)

I tried to setup :48224 L48224 U48224 but not luck on that side.

I am getting the message of "Illegal data Value".

Can somebody tell me what is the proper format?

Title: Re: MODBUS TCP/IP address register for loadcell amplifier
Post by: Godra on September 19, 2019, 08:04:51 PM

See here:

https://www.advancedhmi.com/forum/index.php?topic=2274.msg13230#msg13230

Title: Re: MODBUS TCP/IP address register for loadcell amplifier
Post by: arizawilmer on September 19, 2019, 10:49:28 PM

Quote from: Godra on September 19, 2019, 08:04:51 PM

See here:

https://www.advancedhmi.com/forum/index.php?topic=2274.msg13230#msg13230

Yep,+1bit for this one.


Thanks