AdvancedHMI Software
General Category => Support Questions => Topic started by: Dr pepper on August 01, 2021, 07:12:18 AM
-
I want to find a way to boot the project on power up, operators here are not that bright.
I tried using publish bit soon found thats not the way to do it.
Is there an .exe I can run or some settings to change to get the thing to run the project on power up?
Not had any replies to my other question, I wonder if this forum is still active.
-
I sussed it, for anyone else with this problem:-
Its right at the end of this vid, theres an .exe file in advancedhmi.bin.
https://www.youtube.com/watch?v=QP6iEHrJc_g
-
Not had any replies to my other question, I wonder if this forum is still active.
It's active, but very slow. Not like it used to be for sure.