Messages

1

Support Questions / Re: Omron CJ2 FINS, what address?

« on: September 17, 2015, 10:45:14 AM »

Archie..
thanks for help, CJ2 is working.
I would like to communicate with an NJ (Omron) PLC; i should use an EtherNet/IP driver.
Is the EIP Driver in AB folder useful also for Omron (i have read this in a past post). Anyway have you written an Omron EIP driver?

Thanks for help

2

Support Questions / Re: Omron CJ2 FINS, what address?

« on: September 17, 2015, 09:23:08 AM »

Archie...
setting the protocol at TCP, in wireshark protocol column there is "UDP" label.
then If i changed the protocol to UDP, in wireshark the column labelling "OMRON" and the control read correctly.

So the question is, i am using TCP setting UDP or not?

3

Support Questions / Re: Omron CJ2 FINS, what address?

« on: September 17, 2015, 08:51:07 AM »

Archie...
i have tried: D400, DM400, D400.0 .. none effects. The DigitalPanelMeter labelling also '0'.
any other suggestion?

4

Support Questions / Omron CJ2 FINS, what address?

« on: September 17, 2015, 08:29:47 AM »

Hi all,
i have some problem while using advanced hdmi developer environment. I should comunicate with Omron CJ2M using FINS protocol, so i have added the OmronEthernetFINSCom1 control (protocol Type TCP), DNA and Node at '0'.
Then i added a digitalpanelMeter, but i can't read the memory, e.g. DM400. Which properties i have to fill in the digitalpanelMeter Control? And which format to read DM400 (Data Memory in Omron protocol)?

Thanks for help.
Matteo M.