Messages

1

Support Questions / Re: How to save Multiple builds with different names

« on: October 14, 2016, 05:29:16 PM »

The easiest way to do that would be to go into the Project menu and click Project Properties (the last option) and then change the Assembly Name, as long as that is consistent with the Advanced HMI terms of use.

2

Support Questions / Re: advance HMI and remote connection

« on: October 14, 2016, 05:24:13 PM »

I would make sure you are properly port forwarding through your router, check your firewalls and check to see if you have conflicting IP addresses / ports, also with the correct protocol selected in your router options, TCP and not UDP. In the past, I have seen that one has to add a port forwarder for both protocols, and selecting the wrong one would cause it not to work.

If none of that helps, try assigning your device a static IP address through your router and then repeat the steps over again.

3

Support Questions / Re: No response from PLC during write.

« on: September 30, 2016, 09:43:09 AM »

No wonder, I should have known that.

Thank you!
Weston

4

Support Questions / Re: No response from PLC during write.

« on: September 29, 2016, 11:35:44 PM »

I figured out that RSLinx Enterprise (from FTView) was running in the background even though RSLinx Classic was completely shut down. I have no problem now reading outputs, but I still cannot trigger inputs from AdvancedHMI, any Ideas?

5

Support Questions / Re: No response from PLC during write.

« on: September 29, 2016, 11:09:55 PM »

Hi, thank you for the quick reply.

It is completely shut down now, but I am still unable to communicate with the PLC.

Thanks,
Weston

6

Support Questions / No response from PLC during write.

« on: September 29, 2016, 11:03:58 PM »

Hi,

I was just trying to get AdvancedHMI working with both my SLC-500 and MicroLogix 1200 today and unable to get AdvancedHMI to communicate with either PLC. I receive the message, ' Exception thrown: 'MfgControl.AdvancedHMI.Drivers.Common.PLCDriverException' in MfgControl.AdvancedHMI.Drivers.dll ' in Visual Studio Community 2015. I am trying to communicate through the SerialDF1forSLCMicroCom driver using AdvancedHMI version 3.99r. All the settings for the driver are configured identical to RSLinx and as such, I am unsure of where to go to from here. I, at the moment am trying to use the Momentary Button Control with the PLC input address under PLCAddressClick but with no avail.

Reading through other posts, I haven't found much information on this particular issue but that my Prolific USB to Serial adapter may be the issue; I am still unsure of that because it has worked very reliably since I purchased it.

Thank you,
Weston Miller