Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - alanjr

Pages: [1]
1
Support Questions / Re: Display text
« on: November 20, 2024, 03:33:44 PM »
Archie,

I have been unable to get this to work. Is it possible because the Click PLC has a text address in the 9000h range? (Or starting at 436865 for MODBUS 984 addressing)

Just a guess but I wasn't sure if the driver isn't converting it because of the address range.

Thanks

2
Support Questions / Display text
« on: November 16, 2024, 09:08:09 PM »
Hello,

I have a Click PLC communicating via ModbusTCP. I am able to use the basic label to display a number by setting the PLCAddressValue to the MODBUS address in the Click PLC. However when I try use the MODBUS address for TXT value the basic label displays a 0.

I would appreciate any help.

Thanks

Pages: [1]