1
Support Questions / Re: Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 23, 2019, 07:47:05 AM »
I ended up going with a small form factor PC that runs windows 10 and all is well.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Support Questions / Re: Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 09, 2019, 09:03:44 AM »
Archie it actually is. I will try changing that and post results.
Thank you
Ok I had tried the Autosize = false without any change. Are their any other idiosyncrasies with mono?
Thank you
Ok I had tried the Autosize = false without any change. Are their any other idiosyncrasies with mono?
3
Support Questions / Re: Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 08, 2019, 07:27:40 PM »
Your assumptions are correct and have tried your suggestions without any luck. It would be nice to resolve this for this particular application. It is an NEC V404 display with the raspberry commute module built in the display. This would eliminate the need for a Micro windows PC.
4
Support Questions / Re: Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 08, 2019, 06:03:14 PM »
I am communicating to a AB Controllogix processor. “As expected” means that all the labels and tags / functionality of the application works correctly. Do you have any suggestions for Mono vs Window drivers?
5
Support Questions / Re: Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 08, 2019, 05:08:53 PM »
Yes the Windows 10 PC runs the application as expected without a hangup.
6
Support Questions / Re: Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 08, 2019, 08:58:08 AM »
Not really as far as functionality. The commute module was manufactured for embedded applications and has more GPIO pins available for development.
7
Support Questions / Raspberry PI with Mono Issue | MessageDisplayByBit/Value
« on: January 07, 2019, 08:10:16 AM »
I have a quick question about running AdvancedHMI projects on a Raspberry PI commute module 3. My applications runs correctly except for the MessageDisplayByBit and MessageDisplayByValue items on the project. I have put the recommended library from Windows in the AdvancedHMI/BIN/Debug folder as suggested by Archie but now it just has a blank [not showing anything] where the values need to be.
Has anyone run into this that could lend me a hand to get this off the ground? Am I missing another .dll from windows?
Has anyone run into this that could lend me a hand to get this off the ground? Am I missing another .dll from windows?
Pages: [1]