Messages

1

Open Discussion / Can i use omron ethernet fins driver with cx simulator?

« on: September 13, 2021, 09:21:03 AM »

hey i just wonder, can i use omron ethernet fins driver with cx-simulator, because i can use it with some scada, but i'm stuck with the ip address, how can i use the fins gateway simulation with that driver?

2

Support Questions / Can i use CX-Simulator on OmronEthernetFinsCom Driver ?

« on: September 01, 2021, 03:18:54 PM »

hey i just wonder, can i use omron ethernet fins driver with cx-simulator, because i can use it with some scada, but i'm stuck with the ip address, how can i use the fins gateway simulation with that driver?

3

Support Questions / Re: Analogue Value Display can't read more than one id from modbustcp

« on: August 07, 2020, 01:50:46 AM »

It worked, but i change the click with timer tick every 1s, thanks mate

4

Support Questions / Analogue Value Display can't read more than one id from modbustcp

« on: August 05, 2020, 01:21:31 AM »

Hi, so i was using separate driver with same ip addres, but different id, then i tried to read address from each driver at the same time, but what i got is no response from plc, or com error, is there any solution with multi unit id when using modbustcpcom?