1
Support Questions / Re: OPC server IP as a variable?
« on: February 16, 2022, 01:03:14 PM »
Its working, thank you for the help!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Support Questions / Re: OPC server IP as a variable?
« on: February 16, 2022, 10:48:50 AM »
OK, I added this line to the beginning of OpcDACom.vb and made progress
Implements System.ComponentModel.ISupportInitialize
Implements System.ComponentModel.ISupportInitialize
3
Support Questions / Re: OPC server IP as a variable?
« on: February 16, 2022, 09:58:43 AM »
Thank you.
I did that, and I get these errors when rebuilding:
I did that, and I get these errors when rebuilding:
4
Support Questions / OPC server IP as a variable?
« on: February 16, 2022, 09:14:24 AM »
I have a simple HMI project done, and working, but I'd like to be able to make the IP address of the remote server I'm connecting to a variable that I can edit in an .ini file, rather than having to set it in the driver. I'm using the OpcDACom driver.
Is this possible? After searching the forum it appears it is possible for some drivers (like EthernetIPforCLX..).
I'm very new to AdvancedHMI and not much of a VB programmer, so I apologize if there is an obvious answer that I'm missing.
Is this possible? After searching the forum it appears it is possible for some drivers (like EthernetIPforCLX..).
I'm very new to AdvancedHMI and not much of a VB programmer, so I apologize if there is an obvious answer that I'm missing.
Pages: [1]