This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - How_Hard_Can_It_Be
Pages: [1]
1
« on: March 29, 2023, 11:59:43 AM »
Hi thanks for the response. I thought that was the case but with nothing in the routing and the EN2T card IP address set and PLC slot 1, I still get the no response from PLC message ?
2
« on: March 22, 2023, 10:19:09 AM »
Hi I have just downloaded the HMI package and trying to set things up for the first time. Before I get too involved in the coding I wanted to check I can connect to the test rig.
My connection is going from PC to a Stratix switch to an EN2T card slot 3 IP 192.168.0.11 then via the backplane to the Rockwell PLC in slot 1.
I have downloaded an example project and the EthernetIPforCLXCom1 driver but cannot get connected. Is this the right driver as the examples show the PLC having an IP address my one does not.
Any help with the driver / routing on this would be much appreciated.
Pages: [1]
Show Posts