Messages

1

Support Questions / during blink simulation with 500ms timer pilot light indicator slowly response

« on: June 13, 2024, 08:08:35 PM »

Hello everyone, thank you for allowing me to join this wonderful forum. I have a question: when I run a simulation with CX-Programmer and communicate using a virtual port to Advanced HMI, the reading speed from the pilot light is slow. I have a blink simulation for the coil output with a speed of timer is 500 milliseconds. This output will blink 100 times and be read by the pilot light as an indicator. However, the pilot light can only read 30 blinks and slowly response, and when I repeat the process, I get the same result.

Is there a significant difference between the simulation and the real implementation?

Thanks All
Best Regards