1
Open Discussion / Re: MicroLogix1100 Ethernet comm: "Failed to get processor type"
« on: November 28, 2014, 04:44:48 PM »See this post
http://advancedhmi.com/forum/index.php?topic=505.0
You ARE a superstar! Thank you so much!!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
You ARE a superstar! Thank you so much!!
2
Open Discussion / MicroLogix1100 Ethernet comm: "Failed to get processor type"
« on: November 28, 2014, 01:28:59 PM »
Hi,
I have just starting playing with AdvancedHMI to communicate with MicroLogix1100. All I have on the VisualStudio Express 2012 form design is DigitalPanelMeter and EthernetIPforPLCSLCMicroCom components. Things I configured:
1) DigitalPanelMeter:
*PLCAddressValue: T4:9.ACC (since this is the value I want to display)
2) EthernetIPforPLCSLCMicroCom:
*IPAddress: 192.168.0.20 (this is my PLC address)
When I press START on VisualStudio, I get notification "Failed to get processor type" on the top part of DigitalPanelMeter. What did I do wrong? I have tried stopping the ethernet drive on RSLinx but still nothing.
Any help is appreciated. Thank you!
I have just starting playing with AdvancedHMI to communicate with MicroLogix1100. All I have on the VisualStudio Express 2012 form design is DigitalPanelMeter and EthernetIPforPLCSLCMicroCom components. Things I configured:
1) DigitalPanelMeter:
*PLCAddressValue: T4:9.ACC (since this is the value I want to display)
2) EthernetIPforPLCSLCMicroCom:
*IPAddress: 192.168.0.20 (this is my PLC address)
When I press START on VisualStudio, I get notification "Failed to get processor type" on the top part of DigitalPanelMeter. What did I do wrong? I have tried stopping the ethernet drive on RSLinx but still nothing.
Any help is appreciated. Thank you!
Pages: [1]