v3.99d Failed to get processor type - Line 429

[lwciak]

Try this work around that bypasses the process of fetching the processor type

Sir Arthur & Members of the Court 
Two issues:

• I get the above error when I try and run the "MotorControlAppMicroLogix" listed in the documents section.
• In the MOV instruction, same document, RUNG 0001, I enter the Destination address as shown(O:0.3), but get the error "Address must be specified to the word level"

I have followed the directions you gave me in a previous older post as listed below:

1) Under the AdvancedHMIDrivers project in Solution Explorer, open AllenBradletPCCC.vb
2) go to line 429
3) Insert the line of code "Return &H58" as shown below:
Code: [Select]

    Public Function GetProcessorType() As Integer
        Return &H58

        If m_ProcessorType <> 0 Then

When I follow the above instructions, that code doesn't exist. Am I not doing it right?

Would you please verify or explain the MOV issue I described?
TIA
Larry C aka maltmaster, lwciak

[Archie]

Look in AllenBradleySLCMicro.vb at line 1329, you will see this code:

Code: [Select]

#Region "Data Reading"
    '* Retreives the processor code by using the get status command
    Public Function GetProcessorType() As Integer
        '* Uncomment the following to bypass this check
        'Return &H78
        If m_ProcessorType <> 0 Then