SelectorSwitch3Pos1 always in center position

[Darrell]

 ver 399f , SLCMicro driver , Micrologix 1400  , SelectorSwitch3Pos1 always goes to  center position , PLC value left and right are used , Micrologix 1400

Darrell

[Archie]

- In Solution Explorer, expand down the AdvancedHMIControls project
- Expand down the Controls folder
- Right click SelectorSwitch3Pos.vb and View Code
- Go to line 182 and replace the 2 properties with the following code:

Code: [Select]

    'Private m_ValueLeft As Boolean
    Public Property ValueLeft As Boolean
        Get
            Return (Value = ValueOfLeftPosition)
        End Get
        Set(value As Boolean)
            If Me.Value <> ValueOfLeftPosition Then
                If value Then
                    Me.Value = ValueOfLeftPosition
                ElseIf Not ValueRight Then
                    Me.Value = ValueOfCenterPosition
                End If
                'm_ValueLeft = value
            End If
        End Set
    End Property

    'Private m_ValueRight As Boolean
    Public Property ValueRight As Boolean
        Get
            Return (Value = ValueOfRightPosition)
        End Get
        Set(value As Boolean)
            If Me.Value <> ValueOfRightPosition Then
                If value Then
                    Me.Value = ValueOfRightPosition
                ElseIf Not ValueLeft Then
                    Me.Value = ValueOfCenterPosition
                End If
                'm_ValueRight = value
            End If
        End Set
    End Property


[Darrell]

now works ,
thanks Archie