Home
Help
Search
Login
Register
AdvancedHMI Software
»
General Category
»
Support Questions
»
Trend Chart File Creation
« previous
next »
Print
Pages: [
1
]
Author
Topic: Trend Chart File Creation (Read 1087 times)
DavidSr
Full Member
Posts: 170
Trend Chart File Creation
«
on:
April 06, 2019, 08:10:33 AM »
BETA 30
Created a new chart and set to enable. There is data in the PLC but it is not showing on the chart and no file has been created, Neither has the datalog directory been created.
Logged
David
Archie
Administrator
Hero Member
Posts: 5322
Re: Trend Chart File Creation
«
Reply #1 on:
April 06, 2019, 08:33:29 PM »
Add a BasicLabel to the form and set PLCAddressValue to the same address you put in PLCAddressItems of the ChartWithLogging. Run it to see if the BasicLabel gets a value.
Logged
DavidSr
Full Member
Posts: 170
Re: Trend Chart File Creation
«
Reply #2 on:
April 06, 2019, 09:06:41 PM »
The directory and file were finally created, not sure how long the delay was. I think you have addressed this before, sorry,,, If you could remind me. Is the Directory and file supposed to be created when we do a build?
Logged
David
Archie
Administrator
Hero Member
Posts: 5322
Re: Trend Chart File Creation
«
Reply #3 on:
April 06, 2019, 09:38:08 PM »
The file and directory is created either at midnight or when the application is closed. Do note that if you kill the application by using the stop button in VS or using Task Manager it is not a controlled shut down therefore it will be unable to create the file.
Logged
Print
Pages: [
1
]
« previous
next »
AdvancedHMI Software
»
General Category
»
Support Questions
»
Trend Chart File Creation