Chart by Sampling function

[css@eol.co.nz]

Hi, I am running an Omron CP1h using AHMI on Modbus RTU. My AHMI main form shows the data I have coming in through two analogue inputs.
I am trying to display the AI data using "chart by sampling function" but get hopelessly stuck configuring the chart. When I click on Data, it takes me to an area where i have to select one of three options? Is there anyone that is able to help me on my way. Is there an instruction set associated with this aspect of advance HMI
I have attached the error file showing errors associated with my efforts.

Really appreciate the content of this forum, have helped me a lot getting up and running.

[Archie]

Start with this just to make sure it is not a Visual Studio issue:

https://www.advancedhmi.com/forum/index.php?topic=1062.msg5555#msg5555

[css@eol.co.nz]

Thanks Archie, have followed up your suggestion, no luck. Have uninstalled/re installed Visual Basic and started with a freshly unzipped copy of AHMI. Configured a gauge, works OK on modbus RTU. Configured a chart by sampling, did a build solution. Same list of errors pops up. Have attached the full error listing.
I am using AHMI vs 3.99Y , Microsoft Visual Studio Community 2022 (64-bit) - Current

very much appreciate your help
Regards
Jacques van Selm,

 I am a retired mechanical engineer, helping out a friend who runs a small distillation plant. Bought him a set of 2nd hand level transmitters and ended up trying to configure a control system. Greetings from New Zealand