Guage show wrong value

[Darrell]

Gauge  always seems to go to  full value using ver 399n  Micrologix 1400

[Archie]

Add a BasicLabel next to the gage with PLCAddressValue set to the same address as the gage to show what the value should be.

[Darrell]

Thanks, that is what I had done anyway , was just wondering , think it worked in earlier versions , not sure how fa back though

Darrell

[Archie]

I was thinking to add the BasicLabel in order to see the real value is in the PLC because the tank does post processing on the value. I was going to try to replicate the values you have.

[Darrell]

I think I know what was happening  , I was also using a seven digit display for the same PLC address with a number like 571 with a decimal place showing 57.1 but the same number in the gauge puts it over the scale max of 70  A scale factor of .1 would make it display within the range is this correct.

Sorry man, should have noticed this earlier
Darrell