Home
Help
Search
Login
Register
AdvancedHMI Software
»
General Category
»
Support Questions
»
Omron Host Link and getting started
« previous
next »
Print
Pages:
1
[
2
]
Author
Topic: Omron Host Link and getting started (Read 4257 times)
Archie
Administrator
Hero Member
Posts: 5358
Re: Omron Host Link and getting started
«
Reply #15 on:
May 22, 2018, 05:57:35 PM »
Change your processor from RUN to MONITOR mode
Logged
Archie
Administrator
Hero Member
Posts: 5358
Re: Omron Host Link and getting started
«
Reply #16 on:
May 22, 2018, 06:01:48 PM »
Look at section 4-3-10 of the manual and you will see a table of Execution Conditions that shows you cannot write to the CIO using C-Mode commands while the processor is in Run Mode.
Logged
Ecoli-557
Newbie
Posts: 25
Re: Omron Host Link and getting started
«
Reply #17 on:
May 22, 2018, 06:05:30 PM »
That did it! AND the feedback of 0.0 also works.......
Will you explain the difference and will AHMI work with OmronSerialHostLink in RUN mode?
Logged
Ecoli-557
Newbie
Posts: 25
Re: Omron Host Link and getting started
«
Reply #18 on:
May 22, 2018, 06:06:15 PM »
You just answered my question.
Logged
Ecoli-557
Newbie
Posts: 25
Re: Omron Host Link and getting started
«
Reply #19 on:
May 22, 2018, 06:10:03 PM »
OK, Thanks again for pointing out that I have much more to digest....... <grin>.
I am trying to enable logging and it errors out saying Property Value is not valid.
Now what?
Logged
Ecoli-557
Newbie
Posts: 25
Re: Omron Host Link and getting started
«
Reply #20 on:
May 23, 2018, 05:39:43 PM »
Hello, anyone?
I tried to Enable Logging on Omron Serial Host Link and I get this error:
Property Value is not valid.
I kinda need this logging to better understand what AHMI and the PLC is doing.
Logged
Print
Pages:
1
[
2
]
« previous
next »
AdvancedHMI Software
»
General Category
»
Support Questions
»
Omron Host Link and getting started
