Hydraulic Cylinder Control

[ndzied1]

Hello,

It seems that the Hydraulic Cylinder controls shows the cylinder rod as only fully extended or retracted.

Is there a way to get it to go to a certain position based on a value?

Thanks,
Norm

[Archie]

This one has been in the back of my mind for a while, but I never had a need for it or never had any request it until now. The changes have been started. Once I get an opportunity I'll finish converting it to an analog control. I'll see if I can make this available for the next release of 3.60

[ndzied1]

That is great news!  Thanks.