Raspberry Pi 3 + AHMI + Automation Directs Click PLC

[jasoncircello@gmail.com]

A direct connection will work.  Crossover cables are not really needed for anymore.   

View the click plc manual for the ip address configuration. 

Mine is something like 192.168.100.1
                                   Subnet 255.255.255.0

Configure your pi to something like 192.168.100.5
255.255.255.0

[jsathern]

are you talking of setting the raspberry up for a static ip?

[jsathern]

I keep trying to get this to communicate and I cannot. Is there a missing step in the wright ups that is just assumed the everyone knows and I do not?

[Godra]

Your devices can talk to each other only if they are in the same subnet.
It was suggested to you to change the IP address of your Click PLC to 192.168.2 range.
Have you tried doing so?

Also, look at your reply posted previously:

pi@raspberrypi:~ $ hostname -I
169.254.189.229 192.168.2.16

If these addresses reflect 2 different interfaces, like wired and wireless, then change the IP address of your Click PLC to 192.168.2 range and connect it to the interface that has that 192.168.2.16 address.

[jsathern]

I will try that when I get home today. Working right now

[jsathern]

Ok so the key is setting up the pi for a static ip address. JESUS I FIGURED IT OUT FINALLY!!! Thanks for your guys help

[Phrog30]

Ok so the key is setting up the pi for a static ip address. JESUS I FIGURED IT OUT FINALLY!!! Thanks for your guys help

Umm, Godra told you exactly what to do in post #5.  You didn't figure anything out.

[jsathern]

Good to see everyone is friendly 

[Phrog30]

Not being unfriendly.  Simply pointing out you had the answer for a while.