« previous next »
Pages: [1]

Author Topic: Fan control  (Read 5432 times)

Godra

  • Hero Member
  • *****
  • Posts: 1447
    • View Profile
Fan control
« on: April 10, 2020, 01:09:04 AM »
As for the fan control that has both CW and CCW direction, you could try using the attached control.

The direction is controlled with PLCAddressDirection and the fan is turned on/off with the PLCAddressValue.
See the description attached to these properties.

« Last Edit: May 10, 2020, 12:11:35 AM by Godra »
Logged

mrpservices

  • Newbie
  • *
  • Posts: 1
    • View Profile
Re: Fan control
« Reply #1 on: November 16, 2020, 07:09:44 AM »
Godra

Is it possible to change the colour of the fan from green to red, I would like to indicate if the fan has a fault.
Logged

Godra

  • Hero Member
  • *****
  • Posts: 1447
    • View Profile
Re: Fan control
« Reply #2 on: November 16, 2020, 01:37:32 PM »
The simple answer is No (this is a built-in control which I don't have access to).

If you do have a bit that indicates the fault then put a red LED control above the fan and point the address to that bit.
Logged

MajorFault

  • Guest
Re: Fan control
« Reply #3 on: November 18, 2020, 02:45:24 PM »
You can use a graphic indicator and load your own images.  If you have access to symbol factory you can save different images with different colors.  FTView ME has symbol factory.  I had a control somewhere that had more than a few states, but I can't find it.
Logged
Pages: [1]
« previous next »