Hi
I was looking to run Advanced HMI on a Raspberry Pi, however, I would just like to control the GPIO states of the Pi with it. I am not looking to control any PLCs with it, but just the GPIOs of the Pi on which the Advanced HMI is running. I was following the link:
http://advancedhmi.com/forum/index.php?topic=938.0 and made some contributions as well. However, right now, I am at a kind of a dead end where the GPIOs are not changing states when I try to change them. The details on the solution that has been implemented is on this post:
http://advancedhmi.com/forum/index.php?topic=932.0 .
Any help will be much appreciated. Thanks a lot in advance.
Aviraj
